CAUTION: Before performing any service and adjustments:
1.Stop engine.
2.Make sure the rotating lines and all moving parts have completely stopped.
3.Disconnect spark plug wire from spark plug and place where it cannot come in contact with plug.
TRIMMER
TO ADJUSTTRIMMING HEIGHT
See "TO ADJUSTTRIMMING HEIGHT"in the
OperalJonsectionotW_ manual.
TO ADJUST HANDLE
The upper handle may be adjusted to different height positions.
•Loosen handle knob only enough to allow the upper handle to pivot to the desired position.
•Tighten handle knob securely.
NOTE: The handle knob and bolt may be reversed for left handed operation.
Upper han_e
TO REMOVE/REPLACE TRIMMER HEAD DRIVE BELT
1, Remove screw at front of chassis cover.
2. Lift cover up and away from tdmmer.
Chassis
3.Remove the two (2) screws on sides of trimmer secudng the debris shield.
4.Turn trimmer on its side with carbure- tor and fuel cap up.
5.Remove the two (2) screws on underside of trimmer secudng the debds shield.
6.Slide the debris shield rearward and remove.
7. Remove belt from engine pulley on crankshaft.
pulley
Debris shield screws
Han_e knob
13