LED FUNCTIONS OF CHARGER

LED WILL BE ON TO INDICATE STATUS OF CHARGER AND BATTERY PACK:

Red LED on = Fast charging mode.

Green LED on = Fully charged and in trickle charge mode.

Green LED on = When battery pack is inserted into charger, indicates hot battery pack or that battery pack is out of or below normal temperature range,

Yellow and Green LEDs on = Deeply discharged or defective battery pack,

No LED on = Defective charger or battery pack,

_ CAUTION: To prevent damage to battery pack, remove battery pack from charger immediately if

no LED comes on. Return battery pack and charger to your nearest Sears Service Center for checking or replacing. Also, if you are removing battery pack from charger and no LEDs are on, return both battery pack and charger to your nearest Sears Service Center. Do not insert another battery pack into charger. A damaged charger may damage a battery pack.

TO INSTALL/REMOVE BATTERY PACK

See Figure 2.

Use only the recommended battery pack with your worklight.

_, WARNING: Do not install battery pack to your worklight until you have read and understood all precautions and operating instructions in the manual and printed on battery pack and charger.

BATTERY

PACK

LATCHES

Orient battery pack so that raised rib on battery pack aligns with groove inside worklight. Battery

pack is designed to fit only one way in worklight handle.

Insert battery pack, making sure latches on each side of battery pack snap into place and battery pack is secure in worklight before use.

CAUTION: When placing battery pack in your worklight, be sure raised rib on battery pack

aligns with groove inside worklight handle and latches snap into place properly. Improper assembly of battery pack can cause damage to internal components.

To remove battery pack, locate latches on end of battery pack and depress to release battery pack from your worklight.

SWITCH

See Figure 3.

To turn your worklight on and off, depress switch trigger.

MULTI-POSITION HEAD

See Figure 3.

Your worklight has the feature of a multi-position head that has positive stop clicks at each position. Rotate head to the desired position as shown in the arrows in

Figure 3.

MULTI-POSITION

SWITCH

TRIGGER

Fig. 3

LATCHESTO

 

RELEASEBATTERYPACK

Fig. 2

5

Page 5
Image 5
Craftsman 973.110470 operating instructions To INSTALL/REMOVE Battery Pack, Switch, MULTI-POSITION Head