,_ WARNING: Always wear safety goggles or
safety glasses with side shields when operating
tools. Failure to doso could result inobjects
being thrown into your eyes, resulting in possible
serious injury.
,_k WARNING: Do not allow familiarity with your
drill-driver to make you careless. Remember that
a careless fraction of a second is sufficient to
inflict severe injury.
CHARGING BATTERY PACK
The battery pack for this tool has been shipped ina
low charge condition to prevent possible problems.
Therefore, youshould charge it at least 3 to 5hours
prior to use.
Note: Batteries will not reach full charge the first time
they are charged. Allow several cycles (drilling
followed by recharging) for them to become fully
charged.
TO CHARGE
•Charge battery pack only with the charger and
charging stand provided.
•Make sure power supply is normal house
voltage, 120 volts, 60 Hz, AC only,
•Connect charger to power supply.
•Place battery pack in charging stand. Align raised
ribon battery pack with groove incharging stand.
See Figure 1.
•Press down on battery pack to be sure contacts on
battery pack engage properly with contacts in
charging stand.
• When properly connected, the red light on
charging stand will turn on.
•Note: If charger does not charge battery pack, retum
batterypack, chargerand chargingstand to your
nearest Sears Repair Center for electdcalcheck.
• After normal usage, 3 hours ofcharging time is
required to be fully charged. Aminimum charge
time of 3to 5 hours is required to recharge a
completely discharged tool.
•The battery pack will become slightly warm to the
touch while charging. This is normal and does not
indicate a problem.
•Do not place charger in an area of extreme heat
or cold. It will work best at normal room
temperature.
• When batteries become fully charged, unplug
charger from power supply.
SWITCH
See Figure 2.
Toturn your drill ON, depress the switch trigger.To
turn it OFF, release the switch trigger.
SELECTOR
CENTERPOSITION
(LOCK)
SWITCH
TRIGGER
Fig. 2
VARIABLE SPEED
This tool has a variable speed switch that delivers
higher speed and torque with increased trigger
pressure. Speed is controlled by the amount of switch
trigger depression.
Note: You might hear a whistling or ringing noise from
the switch during use. Donot be concerned, this is a
normal part of the switch function.
SWITCH LOCK
See Figure 2.
The switch trigger can be locked inthe OFF position.
This feature can be used to prevent the possibility of
accidental starting when not in use. To lock switch
trigger, place the direction ofrotation selector in
center position.
_IL WARNING: Battery toolsare always in
operating condition. Therefore, switch should
always be locked when not in use or carrying at
yourside.