8. Use the humidity output regulator control knob to adjust
the intensity of the vapor output. Turning the knob
clockwise will increase the moisture output, turning the
knob counterclockwise with reduce the moisture output.
(see Fig. 10)
Fig. 10
9. When the humidifier runs out of water the power light will turn red, and the mist
output will stop. This is a safety feature to prevent the humidifier from possibly over
heating and damaging the nebulizer. This safety feature uses a water level sensor to
stop the nebulizer once the water level sinks below the required level in the water
basin. Turn the humidifier off and unplug before removing and refilling the water
tank. Please note that the RED Power Light on the humidifier body will stay
on. The (red) light signal indicates that the humidifier is turned on and
needs to be refilled.
INSERTING HUMIDIFIER FILTER
(SOLD SEPARATELY not included with your humidifier)
A humidifier filter is an optional accessory for your Crane Cool
Mist Humidifier. Filters are used to eliminate white dust caused
by hard water and to reduce mold spores and bacteria that can
build up in your humidifier.
Place humidifier filter in humidifier as
shown in Fig. 10A
NOTE: Do not leave filter in humidifier
longer than recommended time. See
Filter instructions.
Filters are not included with the
humidifier and can be purchased
separately.
Fig. 10 A
SET THE CORRECT HUMIDITY OUTPUT
ALWAYS PLACE THE HUMIDIFIER ON AN ELEVATED NON-METALLIC
WATERPROOF SURFACE FOR BEST PERFORMANCE.
Adjust the vapor control so that the
vapor rises up and gets absorbed by the
room air. Do not turn on too high output
as the vapor cannot be absorbed by the
air and accumulates on the surface
around the humidifier.
If the humidifier is placed near a fan or
air conditioning outlet the vapor may be
forced down by the foreign air stream.
Change the location of the humidifier or
reduce the output of the other room
conditioning appliances.
correct wrong
7