
ABBOTT PLASMA BACK PANEL
NOTE:
Wall mounting hardware is not included. The plasma back panel is intended for placement against a wall. If you are unsure about your wall type or what mounting method you should purchase, consult a qualified professional or your local hardware store. It is important that you use the wall anchor appropriate for your wall type.
2C) Insert 1 large screw through wall strap and into unit as shown. A) If possible, fasten wall strap to a wall stud. If not, drill a hole in the wall slightly smaller than the diameter of a hollow wall anchor (not included). Lightly tap with a hammer until the face is flush with the wall.
C) Insert 1 wall screw (not included) through wall strap and into the wall anchor.
Assembly is now complete.
Wall
Wall strap
wall anchor
(not included)
large screw
wall screw (not included)
NOTE: Insert screws 3/4"-1" from the edge of the strap
CLEANING AND CARE
Clean surfaces with a dry or damp soft cloth.
Do not use abrasive cleaners. Do not use furniture wax or polish as the wood is finished with a protective clear lacquer.
NOTE: Contact your television manufacturer to purchase the necessary wall mounting bracket needed to safely mount your TV to the back panel.
Made in China - r01 | Customer Service 800.967.6696 Latest instructions available at www.crateandbarrel.com | Page 2 of 2 |