KINGSTON CORNER MEDIA STAND

NOTE: Do not over

A

B

 

 

tighten the bolts.

 

 

B

A

1 NOTE: In steps 1-5, unit is assembled upside down.

A)Attach bottom panel and shelf panel onto left and right side panels as shown with 2 spring washers, 2 flat washers, and 2 bolts per panel. Secure with a Phillips head screwdriver, but do not over tighten the bolts.

B)Attach back panel onto assembled unit as shown with 4 spring washers, 4 flat washers, and 4 bolts.

2Attach left and right angled panels onto assembled unit as shown by aligning pre-installed dowels with corresponding holes. Secure with 8 spring washers, 8 flat washers, and 8 bolts using a Phillips head screwdriver.

NOTE: Make sure arrows on each cam points towards the nearest edge with holes.

3Insert 2 cams into assembled unit as shown. Make sure arrows on each cam points towards the nearest edge with holes.

A B

B

x4

VIEW FROM BELOW

A x2

4A) Insert 2 cam screws into front frame as shown. Secure with Phillips head screwdriver, but do not over tighten.

B) Attach front frame onto assembled unit by aligning cam screws and dowels with corresponding holes. Secure frame with 4 spring washers, 4 flat washers, and 4 bolts using a Phillips head screwdriver.

Made in Vietnam - r06

Customer Service 800.967.6696 Latest instructions available at www.crateandbarrel.com

Page 2 of 3