Crate & Barrel Loop 64 Media Center CLEANING & CARE, crossbar, leg A, leg B, Fit, cams, leg B, leg A, A) Fit, crossbar, . With a, crossbars, crossbars, C) Attach, , turn each, leg A and B

LOOP 64” MEDIA STAND

A

NOTE: Make sure arrows on each cam points toward nearest edge with holes

B

crossbar

2A) With the assistance of another adult, place the media stand assembly upside down onto a clean, padded surface. Insert 4 cams into each side panel of the media stand assembly as shown. Make sure arrows on each cam points toward nearest edge with holes

B) Insert 2 cams into each crossbar as shown.

leg A

leg B

3Fit cam screws of leg A and leg B into corresponding holes of media stand assembly. With a phillips head screwdriver, turn each cam clockwise until it securely engages each cam screw.

B	C
	A

leg B

leg A

4A) Fit crossbars onto cam screws of remaining leg A and B as shown. Secure cams with a screwdriver.

B) Fit remaining leg A and B into corresponding holes in the crossbars and media stand assembly as shown. Secure all cams.

C) Attach support leg to media stand assembly by turning support leg clockwise. With the assistance of another adult, turn media stand assembly upright.

Assembly is now complete.

CLEANING & CARE

Clean surfaces with a dry or damp soft cloth. Do not use abrasive cleaners. Do not use furniture wax or polish as the unit is finished with a protective clear lacquer.

Made in China - r02 Customer Service 800.967.6696 Latest instructions available at www.crateandbarrel.com Page 2 of 2