BFX100 Bass Amplifier
DSP
BFX100
ON
10 | 11 | 12 | 13 |
10.DSP MODE: Select the type of digital effect(s) applied to the signal with this con- trol. The effects are described as follows:
DELAY: | Slapback delay effect |
ECHO: | Long delay effect with regeneration |
CHORUS: | Chorus effect |
FLANGE: | Light flange effect |
| effect |
OCTAVE: | Adds secondary note one octave |
| lower than original note |
CHO/HALL: | Chorus effect with large hall reverb |
| effect |
RM: | Small room reverb effect |
HALL: | Large hall reverb effect |
11.DSP LEVEL: This is the output level con- trol for the selected DSP effect(s). For a dry signal (no effect), rotate the control full
12.DSP FOOTSWITCH: Connect a one but- ton footswitch (such as the Crate
14 | 15 | 16 | 17 |
13.INSERT: Connect an external effects device using this jack. Use a stereo 1/4” male
14.HEADPHONES: For private listening, connect a pair of stereo headphones into this jack. The internal speaker is disconnected when headphones are plugged in.
15.SPEAKER: Use this jack to connect the amplifier to an external speaker with a mini- mum impedance rating of 4 ohms. The inter- nal speaker is disconnected when this jack is used.
WARNING: TO AVOID POSSIBLE
HEARING DAMAGE, DO NOT
USE HEADPHONES IN THE
SPEAKER JACK!
16.ON LED: This LED will illuminate when the amplifier is turned on.
17.POWER: This switch applies AC power to the amplifier. The amplifier is ON when the side of the switch with the indicator () is depressed.