17. HEADPHONES JACK: Standard

G40CXL Amplifier

14.DEPTH: This control sets the amount or depth of the chorus effect.

15.RATE: This control sets the sweep speed of the chorus effect. Together, these two chorus controls determine the overall chorus effect from a slow, “phas- ing” sound to a lively, shimmering effect and beyond. The stereo nature of the G40CXL gives a “three-dimensional” quality to the unit making it sound full and “alive.”

16.INSERT JACK: This stereo 1/4” jack is a line out (tip)/line in (ring) jack.

17. HEADPHONES JACK: Standard

stereo headphones may be plugged into this jack. This disconnects all speakers from the unit. allowing private listening.

18.ON/OFF LED INDICATOR: The amplifi- er is on when this LED is lit.

19.ON/OFF SWITCH: This is a two-posi- tion switch; the down position will turn the unit on, while the up position will turn the unit off.

REAR PANEL

20

 

21

 

 

 

22

 

23

24

 

 

 

 

 

 

 

 

 

 

 

 

 

MODEL #

SERIAL #

G40CXLA

120 VAC 60 Hz 200 WATTS MAX

EXT. SPEAKER

RIGHT LEFT

CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE CHASSIS. NO USER SERVICEABLE PAERTS INSIDE. REFER ALL SERVICING TO QUALIFIED SERVICE PERSONNEL. TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS APPLIANCE TO PAIN OR MOISTURE.

LINE OUT

RIGHT LEFT

FOOTSWITCH

CH. SELECT/

REVERB CHORUS

made in USA by SLM Electronics 1400 Ferguson Ave. St. Louis, Mo. 63133

20.POWER CORD: Your G40CXL is equipped with a heavy-duty grounded three-wire power cord. Be sure this cord is properly plugged into a safely wired grounded 120 volt, 60 Hz AC power outlet before use. (If your G40CXL was purchased outside the United States, refer to the rear panel for power ratings.) For your safety, never attempt to defeat the ground connection on this cord.

21.E X T E R N A L S P E A K E R J A C K S : These jacks are for additional speaker hookup. Any number of speakers may be added since these jacks are in series with the internal speakers.

22.LINE OUT JACKS: These jacks are used to connect the unit to additional amplifiers or to connect the amp to a

tape recorder or mixing board. Using both the left and right outputs will pre- serve the proper stereo signal. External speakers cannot be connected to these jacks.

23.CHANNEL/REVERB FOOTSWITCH JACK: This jack is to be used with the Channel Selector/Reverb footswitch.

24.CHORUS FOOTSWITCH JACK: This jack is to be used with any standard footswitch to control the chorus. The Chorus Switch (13) must be depressed to enable this footswitch.

Page 3
Image 3
Crate Amplifiers owner manual G40CXL Amplifier, HEADPHONES JACK Standard