GLX30 Guitar Amplifier with DSP
The Front Panel:
1 | 2 | 3 | 4 | 5 | 6 | 7 | 8 | 9 | 10 | 11 | 12 | 13 | 14 | 15 |
1:INPUT: Use this 1/4” jack to connect your guitar to the amplifier by means of a shielded instrument cable.
SOLO CHANNEL: A high gain channel giving you sounds from a slight edge to serious overdrive.
2:GAIN: Use this control to adjust the amount of dis- tortion for the Solo channel.
3:SHAPE: Use this control to adjust to tone of the Solo channel.
4:LEVEL: Use this control to adjust the output level of the Solo channel.
5:SOLO/CLEAN: Use this switch to select the Solo or Clean channel. With the switch in the out position, the Clean channel is selected. When the switch is depressed, the Solo channel is selected.
CLEAN CHANNEL: A normal gain channel designed to give you crystal clear sounds to medium distortion.
6:LEVEL: Use this control to adjust the output level of the Clean channel.
7:LOW: Use this control to adjust the low frequency level of the clean channel.
8:MID: Use this control to adjust the midrange fre- quency level of the clean channel.
9:HIGH: Use this control to adjust the high frequen- cy level of the clean channel.
10:DSP LEVEL: Use this control to adjust the level of the selected digital effect. The DSP effects can be turned on and off by using a footswitch (#16, rear panel).
11:DSP MODE: Use this control to select one of the
16
12:CD INPUT: Use these RCA jacks to connect the output from a CD payer or tape deck to the amplifier. The signal at these jacks is summed into a mono sig- nal which is sent to the internal power amp circuit. Use the CD or tape player’s output level control to adjust the signal for the proper mix with your guitar.
13:HEADPHONES: Use this jack to connect head- phones to the amplifier. The internal speaker is dis- connected when headphones are used.
CAUTION: To avoid possible damage to your hearing, do not use headphones for extended periods of time at extremely loud levels.
14:SPEAKER: Use this jack to connect the amplifier to an external speaker. The internal speaker is dis- connected when this jack is used. The impedance of the external speaker must be 4 ohms or greater.
WARNING: Do not attempt to use headphones in the Speaker jack! Permanent hearing damage could result!
15:POWER: Use this switch to turn the amplifier on (top of the switch depressed) and off (bottom of the switch depressed). The adjacent LED illuminates when the amplifier is turned on.
16:FOOTSWITCH (rear panel, not shown): Use this jack to connect the 1/4” stereo plug on the cable of a
17:POWER CORD (rear panel, not shown): The grounded power cord should only be plugged into a grounded power outlet that meets all applicable electri- cal codes and is compatible with the voltage, power, and frequency requirements stated on the rear panel. Do not attempt to defeat the safety ground connection.
The Digital Effects:
1 | - Small Room Reverb | 9 | - Flange with Reverb and Delay |
2 | - Medium Room Reverb | 10 | - Slow Tremolo Chorus With Reverb |
3 | - Large Room Reverb | 11 | - Chorus with Reverb and Delay |
4 | - Concert Hall Reverb | 12 | - Rotating Speaker |
5 | - Short Slapback with Small Room Reverb | 13 | - Octave Divider |
6 | - Medium Delay with Plate Reverb | 14 | - Touch Wah |
7 | - Long Delay with Large Room Reverb | 15 | - Inverse Wah |
8 | - Slow Deep Flange with Reverb | 16 | - Doubler |
