GLX50 Guitar Amplifier with Digital Signal Processing
The Front Panel:
1 | 2 | 3 | 4 | 5 | 6 | 7 | 8 | 9 | 10 |
NOTE: Channel A and Channel B are independent of each other up to the DSP and CD inputs. The text below
1.INPUT: Use this 1/4” jack to connect your guitar to the amplifier by means of a shielded instru- ment cable.
2.TUNER A / TUNER B: Use this switch to assign the electronic tuner (#16) to Channel A (switch in the out position) or Channel B (switch depressed).
3.CLEAN: Use this control to adjust the output level of the Clean channel.
4.CLEAN / OVERDRIVE: Use this switch to select the Clean channel (switch in the out position) or the Overdrive channel (switch depressed).
5.OD GAIN: Use this control to adjust the Overdrive channel’s input signal gain. This control works in conjuntion with the OD Level control (#9) to set the amount of distortion and the output signal level of the Overdrive channel.
6.HIGH: Use this control to adjust the high frequency level of the output signal. This control has a range of 27dB of boost or cut at 12kHz.
7.MID: Use this control to adjust the midrange frequency level of the output signal. This control has a range of 20dB of boost or cut at 1.5kHz.
8.LOW: Use this control to adjust the low frequency level of the output signal. This control has a range of 28dB of boost or cut at 40Hz.
9.OD LEVEL: Use this control to adjust the Overdrive channel’s output signal level. This control works in conjunction with the OD Gain control (#5).
10.EFFECTS: Use this control to adjust the amount of digital effects applied to the output signal.
4
