|
| ENGLISH | |
| |||
|
|
1 | 2 | 3 | 4 | 5 | 6 | 7 | 8 | 9 | 10 | 11 | 12 | 13 |
1:INPUT: Use this 1/4” jack to connect your guitar to the amplifier by means of a shielded instrument cable.
OVERDRIVE CHANNEL: A high gain channel giving you sounds from a slight edge to serious overdrive.
2:GAIN: Use this control to adjust the amount of distortion for the Overdrive channel.
3:LEVEL: Use this control to adjust the output level of the Overdrive channel.
4.OVERDRIVE SELECT: This switch, when depressed, selects the Overdrive channel. The Clean channel is selected when this switch is in the out position.
CLEAN CHANNEL: A normal gain channel giving you sounds from crystal clean to medium overdrive.
5:LEVEL: Use this control to adjust the output level of the Clean channel.
6:LOW: Use this control to adjust the bass response of the amplifier. Rotating the con- trol counterclockwise reduces the low fre- quency output. Rotating the control clock- wise increases the low frequency output. It may be necessary to reduce the Low fre- quency output at higher volume levels.
7:MID: Use this control to adjust the midrange frequency output of the amplifier. Rotating the control counterclockwise reduces the midrange frequency output. Rotating the control clockwise increases the midrange frequency output.
8:HIGH: Use this control to adjust the high frequency response of the amplifier. Rotating the control counterclockwise
reduces the high frequency output. Rotating the control clockwise increases the high frequency output.
9:REVERB LEVEL
10:HEADPHONES: Use this jack to con- nect headphones to the amplifier. The internal speaker is disconnected when this jack is used. A line level signal can also be obtained from this jack for recording, etc.
CAUTION: To avoid possible damage to your hearing, so not use headphones for extended periods of time at extremely loud levels.
11:EXTERNAL SPEAKER: Use this jack to connect the amplifier to an external speaker. The internal speaker is discon- nected when this jack is used. The imped- ance of the external speaker must be 4 ohms or greater.
WARNING: Do not attempt to use head- phones in the Speaker jack! Permanent hearing damage could result!
12:ON LED: This LED illuminates when the amplifier is turned on.
13:POWER: Use this switch to turn the amplifier on (top of the switch depressed) and off (bottom of the switch depressed).
14:POWER CORD (rear panel, not shown): The grounded power cord should only be plugged into a grounded power out- let that meets all applicable electrical codes and is compatible with the voltage, power, and frequency requirements stated on the rear panel. Do not attempt to defeat the safety ground connection.
3
