Bass Amplifier
The Front Panel:
010
0 | 10 | 0 | 10 |
1 | 2 | 3 | 4 | 5 | 6 | 7 |
1:0dB INPUT: Use this 1/4” jack to connect your instrument to the amplifier by means of a shielded instrument cable. If your instrument has active electronics or high output pickups, or if the amplifier distorts at low settings of the Gain control (#3), use the
2:
3:GAIN: Use this control to adjust the level of the input signal.
4:CONTOUR: Use this control to adjust the tone of the input signal. The Contour control selects the frequency where the effect is centered, giving you a wide vari- ety of tone variations – from a studio
5:CONTOUR ACTIVE: This switch, when depressed, activates the Contour con- trol (#4).
6:LOW: Use this control to adjust the bass response of the amplifier. Rotating the control counterclockwise reduces the low frequency output. Rotating the control clockwise increases the low frequency output. The Low control provides a range of 28dB of boost or cut at 60Hz.
7:LO MID: Use this control to adjust the “thickness” or “fatness” of the amplifier. Rotating the control counterclockwise reduces the lower middle frequency output. Rotating the control clockwise increases the lower middle frequency output. The Low Mid control provides a range of 15dB of boost or cut at 400Hz.
8:HI MID: Use this control to adjust the clarity and definition of the string attack. Rotating the control counterclockwise reduces the upper middle frequency output. Rotating the control clockwise increases the upper middle frequency output. The High Mid control provides a range of 18dB of boost or cut at 1kHz.
4
