TB10 Guitar Amplifier
Congratulations!
You are now the proud owner of the compact Crate TB10 Bass Amplifier. The TB10 features two bands of equalization, a variable Compressor, CD Input jacks, and a jack for headphones.
In order to get the most out of your new amplifier, we strongly urge you to go over the information contained in this user’s guide before you begin playing.
And thank you for choosing Crate.
|
|
|
|
|
|
|
|
|
|
|
| CAUTION |
|
|
| PRECAUCION |
|
|
| ATTENTION |
|
| RISK OF ELECTRIC SHOCK |
|
|
| RIESGO DE CORRIENTAZO |
|
|
| RISQUE D'ELECTROCUTION |
|
| DO NOT OPEN |
|
|
| NO ABRA |
|
|
| NE PAS OUVRIR |
|
|
|
|
|
|
|
|
|
| ||
WARNING: TO REDUCE THE RISK OF FIRE OR ELECTRIC |
| PRECAUCION: PARA REDUCIR EL RIESGO DE INCENDIOS O DESCARGAS |
| ATTENTION: PROTÉGEZ CET APPAREIL DE LA PLUIE ET DE L'HUMIDITÉ | ||||||
SHOCK, DO NOT EXPOSE THIS APPARATUS TO RAIN OR MOIS- |
| ELECTRICAS, NO PERMITA QUE ESTE APARATO QUEDE EXPUESTO A LA |
| AFIN D'ÉVITER TOUT RISQUE D'INCENDIE OU D'ÉLECTROCUTION. POUR | ||||||
TURE. TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT |
| LLUVIA O LA HUMEDAD. PARA DISMINUOIR EL RIESGO DE CORRIENTAZO. |
| REDUIRE D'ELECTROCUTION NE PAS ENLEVER LE COUVERCLE. AUCUNE | ||||||
REMOVE COVER. NO |
| NO ABRA LA CUBIERTA. NO HAY PIEZAS ADENTRO QUE EL USARIO PUEDO |
| PIECE INTERNE N'EST REPRABLE PAR L'UTILISATEUR. POUR TOUTE | ||||||
REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. |
| REPARAR DEJE TODO MANTENIMIENTO A LOS TECHNICOS CALIFICADOS. |
| REPARATION, S'ADRESSER A UN TECHNICIEN QUALIFIE. | ||||||
IMPORTANT SAFETY INSTRUCTIONS
•READ, FOLLOW, HEED, AND KEEP ALL INSTRUCTIONS AND WARNINGS.
•DO NOT OPERATE NEAR ANY HEAT SOURCE AND DO NOT BLOCK ANY VENTILATION OPENINGS ON THIS APPARATUS. FOR PROPER OPERATION, THIS UNIT REQUIRES 3” (75mm) OF WELL VENTILATED SPACE AROUND HEATSINKS AND OTHER AIR FLOW PROVISIONS IN THE CABINET.
•DO NOT USE THIS APPARATUS NEAR SPLASHING, FALLING, SPRAYING, OR STANDING LIQUIDS.
•CLEAN ONLY WITH
•ONLY CONNECT POWER CORD TO A POLARIZED, SAFETY GROUNDED OUTLET WIRED TO CURRENT ELECTRICAL CODES AND COMPATIBLE WITH VOLTAGE, POWER, AND FREQUENCY REQUIREMENTS STATED ON THE REAR PANEL OF THE APPARATUS.
•PROTECT THE POWER CORD FROM DAMAGE DUE TO BEING WALKED ON, PINCHED, OR STRAINED.
• UNPLUG THE APPARATUS DURING LIGHTNING STORMS OR WHEN UNUSED FOR LONG PERIODS OF TIME.
• ONLY USE ATTACHMENTS, ACCESSORIES, STANDS, OR BRACKETS SPECIFIED BY THE MANUFACTURER FOR SAFE OPERATION AND TO AVOID INJURY.
•WARNING: TO REDUCE THE RISK OF ELECTRIC SHOCK OR FIRE, DO NOT EXPOSE THIS UNIT TO RAIN OR MOISTURE.
•SERVICE MUST BE PERFORMED BY QUALIFIED PERSONNEL.
•OUR AMPLIFIERS ARE CAPABLE OF PRODUCING HIGH SOUND PRESSURE LEVELS. CONTINUED EXPOSURE TO HIGH SOUND PRESSURE LEVELS CAN CAUSE PERMANENT HEARING IMPAIRMENT OR LOSS. USER CAUTION IS ADVISED AND EAR PRO- TECTION IS RECOMMENDED IF UNIT IS OPERATED AT HIGH VOLUME.
EXPLANATION OF GRAPHICAL SYMBOLS: | "DANGEROUS VOLTAGE" | "IT IS NECESSARY FOR THE USER TO REFER TO THE INSTRUCTION MANUAL" |
EXPLICACION DE SIMBOLOS GRAFICOS: | = “VOLTAJE PELIGROSO” | = “ES NECESARIO QUE EL USUARIO SE REFIERA AL MANUAL DE INSTRUCCIONES.” |
EXPLICATION DES SYMBÔLES GRAPHIQUES: | "DANGER HAUTE TENSION" | |
|
TB10 Guitar Amplifier
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
1 | 2 | 3 | 4 | 5 | 6 | 7 | 8 | 9 |
| ||||||||
1.INPUT: Connect your bass here by means of a shielded instrument cable.
2.VOLUME: Use this control to adjust the overall output level of the amp.
3.HIGH: Use this control to adjust the high frequency output level. Rotating the con- trol counterclockwise reduces the high frequency output, rotating the control clock- wise increases it.
4.LOW: Use this control to adjust the low frequency output level. Rotating the control counterclockwise reduces the low frequency output, rotating the control clockwise increases it.
5.COMPRESSOR: Use this control to adjust the amount of signal compression - rotating the knob clockwise increases the effect. Compression is a dynamic sonic effect that smoothes the output level regardless of how hard or softly the strings are played. The compressor circuit will remove harshness without affecting the tone.
6.CD INPUT: Use these RCA jacks to connect an external source (such as a CD play- er, tape player or rhythm machine) to the amplifier. The signal at these jacks is summed into a mono signal which is sent to the internal power amp circuit. Use the external source’s output level control to adjust the signal for the proper mix with your instrument.
7.HEADPHONES: Use this jack to connect a pair of stereo headphones for private listening. The internal speaker is disconnected when this jack is used.
8.ON LED: This LED illuminates when the amplifier is on.
9.POWER SWITCH: Use this switch to turn the amplifier on (top of the switch depressed) and off (bottom of the switch depressed).
10.AC LINE IN: (Rear panel, not shown) The grounded power cord should only be plugged into a grounded outlet that meets all applicable electrical codes and is com- patible with the voltage, power, and frequency requirements stated on the rear label.
DO NOT attempt to defeat the safety ground connection.
