Crate Amplifiers TX50DE manual C R A T E, BYPASS No effect applied, SLAP Moderate slapback delay

C R A T E

8
17	18	19	20	21	22	23	24

14.LOW (Active only when the Channel Select switch is in the out position): Use this control to adjust the low frequency level for the instru- ment channel 2.

15.MID (Active only when the Channel Select switch is in the out position): Use this control to adjust the mid frequency level for the instru- ment channel 2.

16.HIGH (Active only when the Channel Select switch is in the out position): Use this control to adjust the high frequency level for the instru- ment channel 2.

17.LEVEL (Active only when the Channel Select switch is in the out position): Use this control to adjust the output level of the instrument channel 2.

18.DSP SEND: Use this control to adjust the amount of Digital Signal Processing (DSP) applied to the instrument channel.

19.DSP MODE: Use this control to select the type of Digital Signal Processing (DSP) effect applied to the signal. The nomenclature around the control is as follows:

BYPASS: No effect applied

SLAP: Moderate slapback delay

DELAY: Moderate delay with regeneration

ECHO: Long delay with regeneration CHORUS: Moderate chorus effect ROTARY: Simulated rotating speaker effect

CHO/HALL: Chorus combined with large reverb

ROOM: Small reverb effect

HALL: Large reverb effect

20.CD INPUT: Use these jacks to connect the outputs of a CD player or tape player to the amplifier. The output of the CD or tape player may need to be attenuated for a suitable mix with the input channels – see the notes on page 10.

21.FOOTSWITCH: Use this jack to connect a two-button footswitch to the amplifier. The footswitch may be used to remotely control the Instrument channel selection and turn the DSP on and off. The jack is wired as follows:

Tip = Channel Selection

Ring = DSP control

Sleeve = Ground

22.HEADPHONES: Use this jack to connect a pair of stereo headphones for private practice sessions. The internal speakers are discon- nected when headphones are used.

23.LED: When the power switch is on and the battery is fully charged, this LED illuminates yellow. The LED illuminates red when the bat- tery needs recharging.

24.POWER: Use this switch to turn the amplifi- er on (top of the switch depressed) or off (bot- tom of switch depressed).

7