Crate Amplifiers VC-5212T owner manual Rear Panel

VC-5212T Guitar Amplifier

The Controls and their Functions:

(Reverb cables: do not disturb)

9 10 10 11 12 13

THE REAR PANEL:

9.Power cord connects the amplifier to a suitable source of A.C. voltage. This is a grounded, three-wire cord and must be con- nected to a properly grounded outlet. DO NOT attempt to defeat the ground connection of the power cord! If your amp was purchased outside of the United States, see the sticker next to the A.C. connector for its power ratings. Follow the above guidelines.

10.Power Tubes: 6L6GC (2).

11.Power Amp Phase Splitter Tube: 12AX7A / 7025 (1).

12.Preamp Tube: 12AX7A / 7025 (1).

Replace tubes ONLY with same types! Refer to the enclosed booklet about Tubes and Tube Amplifiers for additional informa- tion.

13:Footswitch Jack is located on the bottom of the amplifier chassis, just past the cabinet’s covered back panel. Connect the supplied footswitch here for remote control of the Reverb and Tremolo on/off.