Start and Programmes
GB
Choosing a programme
1.Plug the dryer into the electrical socket.
2.Sort your laundry according to fabric type (see Laundry).
3.Open the door and make sure the filter is clean and in place and the water container is empty and in place (see Maintenance).
4.Load the machine and make sure items are not in the way of the door seal. Close the door.
5.Choose a drying programme by checking the Programmes table (see Programmes) as well as the indications for the type of fabric (see Laundry).
-Set the temperature with the HEAT button.
-Select a programme or drying time by rotating the PROGRAMME knob.
6.If you wish the buzzer to sound at the end of the programme, press the ALARM button.
7.Press the START button to begin.
During the drying programme, you can check on your laundry and take out items that are dry while others continue drying. When you close the door again, press the START button in order to resume drying.
8.About 10 minutes before the programme is completed, it enters the final COOL TUMBLE phase (fabrics are cooled), which should always be allowed to complete.
9.Open the door, take the laundry out, clean the filter and replace it. Empty the water container and replace it (see Maintenance).
10.Unplug the dryer.
Water container and empty water light
If you have plumbed your dryer to a drain this light can be ignored, as there is no need to empty the water container.
When this light is on (not flashing) it reminds you to empty the water container.
If the water container fills during a programme, the light flashes and the dryer does the Cool Tumble phase (see Programmes). You must empty the water container and restart the dryer or the clothes will not dry. After
To avoid this always empty the water container each time you use the dryer (see Maintenance).
4
