Creda manual Programmes Sensor Dryers Model TVS3 only, Speedy Iron, Fabric

Programmes (Sensor Dryers: Model TVS3 only)

GB	Programme	What it does...	How to set it...		Note:
	Sensor	Dries completely:	1. Select HIGH HEAT by pressing the		! If you select LOW (Gentle)
	Drying	your clothes are ready to be	HEAT button.		HEAT, this programme will
	(average	worn.	2. Position the PROGRAMMES knob		not dry your clothes. For
					Acrylic fibres or small loads
	loads)	For average loads (from 1 to	on .		select Timed Drying.
			3. Press the START button..
		3kg) of Cotton, polycotton or			This programme can also be
		synthetics.
					used for large loads if you
					require a slightly drier result.
	Automatic	Dries completely:	1. Select HIGH HEAT by pressing the		! If you select LOW (Gentle)
	Drying	your clothes are ready to be	HEAT button.		HEAT, this programme will
	(large	worn.	2. Position the PROGRAMMES knob		not dry your clothes. For
					Acrylic fibres or small loads
	loads)	For large loads (from 3 to 5kg) of	on .		select Timed Drying.
			3. Press the START button.
		Cotton.			This programme can also be
					used for average loads if you
					prefer a damper result.
	Speedy	Brief programme (approximately	1. Select HIGH HEAT by pressing		! This is not a drying
	Iron	10 minutes) that softens fibres of	the HEAT button.		programme (see below).
		clothing that is ready for ironing.	2. Position the PROGRAMMES knob
			on	.
			3. Press the START button.
	Timed Drying	Dries wet clothes that will be	1. Select required heat setting HIGH		Consult suggested drying
	up to 120 minutes	ironed, Acrylic fibres or small	HEAT	or LOW (Gentle) HEAT by	times (see Laundry).
		loads (less than 1kg).	pressing the HEAT button.
			2. Position the PROGRAMME knob
					This programme can be used,
			on the desired time.
					if you prefer to use a timed
			3. Press the START button.		drying programme for any
					load.
	Cool	Heating elements turn	This is the programmes final phase.		Always allow the dryer to
	Tumble	themselves off and clothing is	Approximately 10 minutes before the		complete this phase.
	Phase	cooled down.	finish, the knob advances
			automatically to the Cool Tumble
			Phase. After the Buzzer will sound (if
			selected) and the clothing is ready
			to be taken out.

Speedy Iron

‘Speedy Iron’ is a short 10 minute programme (8 minutes of heat followed by a 2 minute cool tumble period) which fluffs the fibres of clothing that have been left in the same position/location for an extended period of time. The cycle relaxes the fibres and makes them easier to iron and fold.

!‘Speedy Iron’ is not a drying programme and should not be used for wet articles of clothing.

For best results:

1.Do not load more than the maximum capacity. These numbers refer to the dry weight:

Fabric	Maximum load
Cotton and Cotton mixtures	2.5kg
Synthetics	2kg
Denim	2kg

2.Unload the dryer immediately after the end of the drying programme, hang, fold or iron the articles and put them away in the closet. Should this not be possible repeat the programme.

The ‘Speedy Iron’ effect varies from one fabric to the next. It works well on traditional fabrics like Cotton or Cotton mix, and less well on acrylic fibres and on materials such as Tencel®.

6