infiNET™ Switches Crestron CLW-SW1/4RF, -SWS1/4RF, -SLVS1RF the start of Acquire mode (Acquire mode does not actually start until you release the
button). Continue holding the button for another five seconds, and the LED will flash
twice to indicate that the gateway connection will be released on the release of the
button. Continue holding the button an additional ten seconds (20 seconds in all)
until the LED flashes three times and release the button. The unit is now running the
bootloader. New firmware can now be uploaded from Crestron Toolbox.
To exit the bootloader and restore the firmware that is currently installed, cycle
power to the device by setting the mode selection switch to “OFF” and back to
“RUN” or “SET”.
Further Inquiries If you cannot locate specific information or have questions after reviewing this
guide, please take advantage of Crestron's award winning customer service team by
calling the Crestron corporate headquarters at 1-888-CRESTRON [1-888-273-7876].
For assistance in your local time zone, refer to the Crestron website
(www.crestron.com) for a listing of Crestron worldwide offices.
You can also log onto the online help section of the Crestron website to ask
questions about Crestron products. First-time users will need to establish a user
account to fully benefit from all available features.
Future Updates As Crestron improves functions, adds new features, and extends the capabilities of
the device, additional information may be made available as manual updates. These
updates are solely electronic and serve as intermediary supplements prior to the
release of a complete technical documentation revision.
Check the Crestron website periodically for manual update availability and its
relevance. Updates are identified as an “Addendum” in the Download column.
38 • infiNET Switches: Crestron CLW-SW1/4RF, -SWS1/4RF, -SLVS1RF Operations Guide - DOC. 6397