Crestron electronic IPAC Installation

Integrated Professional Automation Computer Crestron IPAC

Installation The following tools are required for installation of an IPAC:

• Philips screwdriver

• Flat screwdriver; 3/32” (2.4 mm) blade size

Use the four included 06-32 x ¾” screws to install the mounting plate on the electrical

box. Refer to the diagram below.

NOTE: The ground wire from the mounting plate must be attached to an earth ground.

Make the necessary connections as called out in the illustration below. Details for each

connector can be found below and on the following pages.

NOTE: Complete all other connections before wiring the 4-position NET connector.

Hardware Connections for the IPAC (Shown with Mounting Plate Attached)

2 • Integrated Professional Automation Computer: IPAC Installation Guide – DOC. 6696A