Crestron electronic SRD-SPL-4 Industry Compliance , Installation

Four-Way Amplified Splitter Crestron SRD-SPL-4

Industry Compliance

As of the date of manufacture, the SRD-SPL-4 has been tested and found

to comply with specifications for CE marking and standards per EMC

and Radiocommunications Compliance Labelling.

Installation of the SRD-SPL-4 splitter consists of the following. Refer

also to the “Block Diagram” on page 2.

Attach the RG-6 cable from the antenna to the port labeled IN on the

splitter.

•

• Attach RG-6 cables (up to 70 ft) to the splitter OUT ports and route

them to the radios. Use the four supplied 3-foot cables to adapt the

F-male connector on the RG-6 cables to the SMB-jacks on the radios.

NOTE: For best results in all configurations, use quad-shielded RG-6

cable whenever possible.

4 • Four-Way Amplified Splitter: SRD-SPL-4 Installation Guide – DOC. 6727A