Crestron electronic WPR-48 Setup

As of the date of manufacture, this unit has been tested and found to comply with

specifications for CE marking and standards per EMC and Radiocommunications

Compliance Labelling (N11785).

NOTE: This device complies with part 15 of the FCC rules. Operation is subject to

the following two conditions: (1) this device may not cause harmful interference, and

(2) this device must accept any interference received, including interference that may

cause undesired operation.

NOTE: This equipment has been tested and found to comply with the limits for a

Class B digital device, pursuant to part 15 of the FCC Rules. These limits are

designed to provide reasonable protection against harmful interference in a

residential installation. The equipment generates, uses and can radiate radio

frequency energy and, if not installed and used in accordance with the instructions,

may cause harmful interference to radio communications. However, there is no

guarantee that interference will not occur in a particular installation. If this

equipment does cause harmful interference to radio or television reception, which

can be determined by turning the equipment off and on, the user is encouraged to try

to correct the interference by one or more of the following measures:

 Reorient or relocate the receiving antenna.

 Increase the separation between the equipment and receiver.

 Connect the equipment into an outlet on a circuit different from that to which the

receiver is connected.

 Consult the dealer or an experienced radio/TV technician for help.

Setup

Power for the WPR-48 is provided by the built-in, rechargeable 3.6 VDC lithium-ion

battery. (The unit is shipped with the battery charged.) The battery is recharged when

the WPR-48 is placed in the companion docking station (WPR-DS). Note that the

docking station is also used during configuration procedures and when uploading

new firmware to the WPR-48. When the docking station is being used for

configuration or firmware functions, the recharge circuits are automatically turned

off.

The WPR-48 can be configured to transmit either RF or IR signals. (By default, the

units are shipped as RF devices.) Every WPR-48 transmitter communicating with a

Cresnet system via RF requires a unique RF ID to secure RF communications.

Similarly, every WPR-48 transmitter communicating with a Cresnet system via IR

signals requires a unique IR ID to secure IR communications. The unit’s default RF

Operations Guide – DOC. 6254A Waterproof Wireless Handheld Remote: WPR-48 • 5