Crestron electronic WPR-48 Waterproof Wireless Handheld Remote Crestron WPR-48

Waterproof Wireless Handheld Remote Crestron WPR-48

WPR-48 Physical Views.

The only connectors on the WPR-48 are the two contacts on the back panel. These

contacts are used for charging the long-life lithium-ion battery when the unit is

placed in the WPR-DS docking station. These contacts are also used when

configuring the unit and when firmware is uploaded via the docking station.

NOTE: During configuration and when firmware is being uploaded, the charging

circuits in the docking station are automatically disconnected.

The WPR-48 has nine three-position buttons, which can be configured, using the

Crestron Viewport, for 9-, 18-, 27-, or 48-function operation. Actual button functions

are defined in the SIMPL Windows program, based on the application of the unit

within the Cresnet system.

The only indicators on the hand-held WPR-48 are the four LEDs on the face of the

unit, above the button function windows. The B LED (red) blinks if the battery

charge is low; the T LED (red) illuminates when the WPR-48 is transmitting. The

operation of the J LED (red) and the K LED (red) depends on the unit’s

configuration. In a 48-button configuration, the J LED indicates that the unit is

transmitting ‘page 1’ functions; the K LED indicates that the unit is transmitting

‘page 2’ functions. In the 9-, 18-, and 27-button configurations, there are no ‘page’

functions. If the configuration is set up to allow key presses to change the unit’s RF

or IR ID, these two LEDs illuminate simultaneously during ID reprogramming (refer

to “Setting RF/IR ID via Button Presses” on page 9 for details).

4 • Waterproof Wireless Handheld Remote: WPR-48 Operations Guide – DOC. 6254A