5
Electrical connection
• Do not use an extension cord or double adaper.
• If the supply cold is damaged, it must be replaced by a qualified person in order to avoida hazard.
• If the machine will not be used for an extended time, unplug it and shut off the water supply.
• Connect the machine to a grounded outlet in occordance with current wiring regulations.
• The appliance must be positioned so that the plug is easily accesible.
Connecting water supply hose
• Water supply pressure must be between 4.5 and 145 PSI
(30~1000 kPa).
• Do not crossthread when connecting inlet hose to the valve. If
the water supply pressure is more than 145 PSI, a pressure
reducing device should be installed.
• Two Sealing washers are supplied with the water inlet hoses to
prevent water leaks.
• Check for leakage of washing machine connections by turning
the tap completely on.
• Periodically check the condition of the hose and replace the
hose if necessary.
• Make sure that there is no kink in the hose and that it is not
crushed.
• Be sure that the two water input ports are connected to the
correct water faucets. The connector for hot water is colored red.
NOTE:Washing Machine is to be connected to the water mains using new hoses.
Old hoses should not be used
Repairs to the washing machine must only be carried out by qualified personnel. Repairs carried out by
inexperienced persons may cause injury or serious malfunctioning. Contact your local service center.
Do not install your washing machine in a room where temperatures below freezing may occur.
Frozen hoses may burst under pressure. The reliability of the electronic control unit may be impaired at
temperatures below the freezing point
If the appliance is delivered in the winter months and temperatures are below freezing, store the washing machine
at room temperature for a few hours before putting it into operation.
Drain system
• Never forget to install drain hose before operating your washer.
• Open the packing box, and there is a drain hose inside the drum.
• Connect the drain hose to the drain outlet at the back side of the washer.
• Top of laundry tub must be at least 24 inches high and no higher
than 40 inches from bottom of washer.
• When installing the drain hose to tub(sink), secure it tightly with a string.
• Proper securing of the drain hose will protect the floor from damage due to water leakage.
• When the drain hose is too long, do not force it back into the washer. This will cause abnormal noise.
min. 24inch
max. 40inch
min. 24inch
max. 40inch
min. 24inch
max. 40inch