10The exclamation pointwithin an equilateraltriangle is intended toalert user to thepresence of importantoperating andmaintenance (servicing)instruction in theliterature accompanyingthe appliance.RISK OF ELECTRIC SHOCKDO NOT OPEN

CAUTION

The lighting flash witharrowhead symbol, withinan equilateral triangle, isintended to alert user tothe presence of uninsulated"dangerous voltage" withinthe product's enclosurethat may be of sufficientmagnitude to constituterisk of electric shockto persons.CAUTION: TO REDUCETHE RISK OF ELECTRICSHOCK, DO NOT REMOVECOVER (OR BACK). NOUSER - SERVICEABLEPARTS INSIDE. REFERSERVICING TO QUALIFIEDSERVICE PERSONNEL.
Specification
Frequency Range : AM 530 - 1710 KHz
: FM 87.5 - 107.9 MHz
Power Supply : AC Adaptor DC15V 1.3A
Power Consumption : 23W
Antennas
:
External
antenna Wire
for FM
:
External loop antenna
for AM
Speaker : 2 ¾ 8ohm 5W x 2
WARNING:
TO PREVENT FIRE OR SHOCK HAZARD, DO NOT EXPOSE THIS
APPLIANCE TO RAIN OR MOISTURE. DO NOT REMOVE COVER.
PILOT LAMPS SOLDERED IN PLACE. NO USER SERVICEABLE
PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE
PERSONNEL.
*DESIGN AND SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTICE.

General

Troubleshooting :Symptom Possible Problem Solution
Does not turn on AC adaptor isnt plugged into a
working wall socket or not plugged
into the power supply jack on back
of the unit
Plug the AC adaptor into a working wall socket and
plug the connector into the supply jack on the unit
Doesnt respond Requires a reset If unit is plugged in and doesnt respond, try
resetting the unit by following these steps:
a) remove iPod from dock
b) unplug unit from power source
c) remove back up batteries
d) wait 1 hour, then resume use
iPod does not dock
properly
Using no or wrong iPod insert Make sure the dock insert is the proper fit for your
iPod
iPod didnt install properly Remove your iPod from the dock and check for
obstruction on the connectors in the dock and on
your iPod. Then reseat it in the dock.
Battery Low icon always
flashing
Batteries are weak Replace with new batteries
Batteries were not installed properly Check to make sure polarity(+ and - ends)matches
the diagram in the battery compartment
iPod does not respond
to the unit/iPod is playing
but no sound comes out
iPod is not installed properly Remove your iPod from the dock and check for
obstruction on the connectors in the dock and on
your iPod. Then reseat it in the dock.
Your iPod software is too old Upgrade on your iPod. For details visit
http://www.apple.com/ipod/download
iPod is locked up/plays but no
sound comes out
Check the volume setting. Make sure your iPod is
working properly before docking into the unit.
Please refer to your iPod manual for details. See
above for software upgrade information.
you may need to reset your iPod. To do so:
a) Toggle the Hold switch to hold position, then off.
b) Press and hold the Menu and center Select
button at the same time until apple logo
appears. You may need to repeat this step.
Using 1st or 2nd generation iPod,
iPod Shuffle or other devices.
It cannot control those iPods or other devices.
Remote Control didnt
work
Battery weak Replace current battery with new battery
Remote Control is not pointed
toward it remote sensor
Point the Remote Control towards the remote
sensor (to the left of the display), move within
10 feet of the unit.
Radio/iPod performance is
erratic
It is reaction to external interference Move unit away from potential sources of external
interference such as computers, modems, wireless
devices(routers) or fluorescent light
No sound from unit Volume is set too low on unit Make sure volume is turned up
iPod didnt charge up iPod is not installed properly Remove your iPod from the dock and check for
obstruction on the connectors in the dock and
on your iPod. Then reseat it in the dock.
iPod is locked up/frozen Please make sure your iPod is working properly
before docking into the unit. Please refer to your
iPod manual for details.
iPod battery has problem