Marking plate was located on bottom enclosure

CAUTION:

TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR
BACK). NO USER - SERVICEABLE PARTS INSIDE. REFER SERVICING TO
QUALIFIED SERVICE PERSONNEL.
The lighting flash with arrowhead symbol, within an equilateral triangle, is
intended to alert user to the presence of uninsulated "dangerous voltage"
within the product's enclosure that may be of sufficient magnitude to constitute
risk of electric shock to persons.
The exclamation point within an equilateral triangle is intended to alert user
to the presence of important operating and maintenance (servicing) instruction
in the literature accompanying the appliance.
CAUTION
For Compact Disc Units Only:
INVISBLE LASER RADIATION WHEN OPEN AND INTERLOCK FAILED
OR DEFEATED. AVOID DIRECT EXPORSURE TO LASER BEAM.
11
Connecting Optional Equipment
Specification
Frequency Range : AM 530 - 1700 KHz: FM 88 - 108 MHzPower Supply : AC 120V ~ 60HzPower Consumption : 18WAntennas : External antenna for FM: Built-in ferrite bar for AMSpeaker : 4 8 ohm 5W x 2Replacement Needle : NP4
*DESIGN AND SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTICE.
WARNING:To reduce the risk of fire or electric shock, do not expose this appliance to rain or moisture.CAUTION:Use of controls or adjustments or performance of procedures other than those specifiedmay result in hazardous radiation exposure.There is no Power
1The AC plugged is not well connected.
2Make sure the Power Button is pushed in.
There is no Sound
1Check the volume level by turning the volume
knob.
2Make sure the LINE IN SWITCH is in the OFF
position if the LINE IN JACK is not being used.
Turntable will not work
1Make sure the function switch is set to phono.
2Make sure the protective needle cover is
removed.
CD does not play
1Check to make sure CD is inserted correctly
(label side facing up).
2Check that the surface of the CD is clean
3Make sure function switch is set to CD.
Troubleshooting
Auxiliary Input
1You can connect external components to your
unit by using the Auxiliary Input.
2Plug Auxiliary cable into the LINE IN Jack (26)
on the back of your unit.
3Switch the LINE IN Switch (27) to the ON
position.
4Plug the other end of the Auxililary cable into
the output jack on your desired external
component.
5Check the volume level of your external
component.
6See operators manual for correct operation of
the external component.
NOTE: When not using the Auxiliary Input, make
sure the LINE IN Switch (27) is in the
OFF position.
RISK OF ELECTRIC SHOCKDO NOT OPEN

CAUTION