Fig. 3
1.80"
45.7mm dia.
7.530"
191.2 mm
CM-200A
Fig. 4
|
|
| 1:1 XFMR |
|
|
|
1 | 2 | CT | 2 |
| 1 | TO MIXER |
TO MIC |
|
|
|
|
| |
| 3 |
|
| 3 |
| MIC INPUT |
|
|
|
|
|
.840"
+
21.3 mm18V (TWO
dia.
100mF 25V
|
|
|
| + |
|
|
1 |
| 2 | 1K | 2 | 1 | TO MIXER |
|
| |||||
TO MIC |
|
|
|
|
| MIC INPUT |
| 3 |
| 1K | 100mF 25V | 3 | |
|
|
| ||||
|
|
| + |
|
+
18V (TWO
MATCH RESISTORS WITHIN 1% (10 OHMS)
For outdoor or vocal use, you may want to place the included foam windscreen on the microphone to reduce wind noise and breath popping.
Several placement examples are described in the Crown Microphone Application Guide, available from your Crown dealer, the Crown Literature Department, or on Crown’s web site at www.crownaudio.com.
Architects’ and Engineers’ Specifications
The microphone shall be the Crown Model
The microphone shall have a sensitivity of 2.2 mV/Pa
Warranty
Crown professional microphone products are guaranteed against malfunction for a period of three years from date of original purchase. See enclosed warranty sheet for additional information.
Service
If the microphone does not function properly, replace or repair the mic cables and check the power supply.
If you determine the product is defective, return the complete product in its original packaging to:
Crown Factory Service, 1718 West Mishawaka Road, Elkhart, IN 46517-9439.
A Service Return Authorization (SRA) is re- quired for product being sent to the factory for service. An SRA can be completed on line at www.crownaudio.com/support/factserv.htm.
For further assistance or technical support call
Crown International, Inc. 1718 W. Mishawaka Rd. Elkhart, IN
©2008 Crown Audio®, Inc. Crown and Crown Audio are registered trademarks of Crown International. Specifications subject to change without prior notice. Latest information available at www.crown- audio.com.
5/08 |