K Series Power Amplifiers
4 Operation
4.3Back Panel Controls and Connectors
Figure 4.3 below points out the controls and connectors on the back panel of the K Series amplifiers. The K1 and K2 look identical except for product nameplates and fuse specifications.
E. Bridge Output Switch
This switch selects whether or not the output signal is bridged across the two channels. To operate the amplifier in
F. “Y” Input Switch
If you want to feed a mono audio signal to two channels, each with its own level control, set the “Y” Input switch to ON. This connects the
input signals of both channels together, in par- allel. To operate in dual mode, set this switch to OFF. See Section 3.6.1 for more detail.
G. XLR-type Input Connector
This is a female
H. Input Sensitivity Switch
This switch selects between1.4V sensitivity or 26 dB gain. See Section 3.6.2 for more detail.
I. Phone Jack Input Connector
This is a
J. Power Fuse
This fuse protects the
K. Power Cord
This permanently attached cable conducts the AC mains electricity to the amplifer.
L. Output Connectors
These
Figure 4.3 Back Panel Controls and Connectors
Operation Manual | page 11 |