2 Setup
2.6 Wire Your System
2.6.1 Stereo Mode
Typical input and output wiring is shown in
Figure 2.7
INPUTS: Connect input wiring for both channels.
OUTPUTS: Maintain proper polarity
Connect Channel 1 loudspeaker’s positive (+) lead to Channel 1 positive (red) terminal of amp; repeat for negative
Figure 2.7 shows how to wire stereo speakers to the 5-way binding posts.
To wire stereo speakers to the Speakon® connectors, use one of these methods:
Method 1 (Table 1 and Figure 2.8): Wire one Speakon cable con- nector to two speakers. Insert the Speakon cable connector into the amplifier’s top Speakon connector.
Method 2 (Table 2 and Figure 2.9): Plug the Channel 1 speaker into the Channel 1 (top) Speakon connector, and plug the Channel 2 speaker into the Channel 2 (bottom) Speakon connector.
Table 1
XLS Series Power Amplifiers
Figure 2.7
System Wiring,
Stereo Mode
Using the
Binding Posts
Stereo Wiring Method 1: Use Top Speakon Only
PIN | 1+ | 1– | 2+ | 2– | |||
|
|
|
|
|
|
|
|
CH | 1+ | 1– | 2+ | 2– | |||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Figure 2.8 Stereo Wiring Method 1: Wire Two Speakers to the Top Speakon Connector
| Table 2 |
|
| |
Stereo Wiring Method 2: Use Both Speakons | Top Speakon | |||
(Channel 1) | ||||
|
|
| ||
PIN | 1+ | 1– |
| |
CH | 1+ | 1– | Channel 1 | |
|
|
| ||
|
|
| Loudspeaker | |
PIN | 1+ | 1– |
| |
CH | 2+ | 2– | Bottom | |
|
|
| Speakon | |
|
|
| (Channel 2) | |
|
|
| Channel 2 | |
|
|
| Loudspeaker | |
Figure 2.9 Stereo Wiring Method 2:
Connect Each Speaker to a Different Speakon Connector
page 8 | Operation Manual |
