Crown Boiler PN980528R1 dimensions Gas-Fired, Direct Vent Hot Water Boiler, DIMENSIONS in inches

Gas-Fired, Direct Vent

Hot Water Boiler

DIMENSIONS ( in inches ) CROWN Co-axial Horizontal Vent Terminal

*Air inlet collar located on center rear of CWD193 through CWD245

CWD SERIES SPECIFICATIONS

		AGA	D.O.E	IBR NET	COLLAR		WIDTH		SHIPPING
Model	NO. OF	INPUT	HEATING	WATER	DIAMETER
	SECS.	BTU/HR	CAPACITY	RATING	INLET	EXHAUST	A	AFUE	WEIGHT
			BTU/HR	BTU/HR.	(inches)	(inches)	(inches)	(%)
CWD060	3	60,000	51,000	44,000	4”	3”	16-1/8	85.1	280
CWD083	4	82,500	71,000	62,000	4”	3”	19-3/4	85.1	315
CWD110	5	110,000	94,000	82,000	4”	3”	23-3/8	85.2	350
CWD138	6	137,500	118,000	103,000	4”	3”	27	85.2	385
CWD165	7	165,000	142,000	123,000	4”	3” or 4”	30-5/8	85.2	420
CWD193	8	192,500	165,000	143,000	4”	3” or 4”	34-1/8	85.2	475
CWD220	9	220,000	189,000	164,000	4”	3” or 4”	32-3/4	85.2	525
CWD245	10	245,000	211,000	183,000	4”	3” or 4”	41-3/8	85.3	580

LOCATING THE BOILER

• Clearances: Sides 1”, front 3”, rear 1”, top 12”	1.	Altitudes above 2,000 ft.–ratings should be reduced at a rate of 4%
• 6” clearance to air inlet collar when combustion air is supplied from indoors		for each 1,000 ft. above sea level (U.S.A. only), in Canada, boilers are
• Boiler may be installed directly on a non-carpeted combustible floor		certified for altitudes up to 2,000 feet only.
	2.	Please specify fuel (natural gas or LPG).
• Relief valve may not be moved from factory location
	3.	Specifications and dimensions are subject to change without notice.
Important:This boiler requires a special venting system.

Read instructions carefully before installing.

Heat Exchanger constructed and tested in accordance

with ASME Section IV standard.

AVAILABLE FROM:

Since 1949, homeowners have depended on us for quality, value and service

3633 I Street, P. O. Box 14818 Philadelphia, PA 19134

Phone: (215) 535-8900 Fax: (215) 535-9736

Visit us on the web: www.crownboiler.com

CWD-11/05-(20M) PN980528R1