c.Attach center top of bag from inside of bag.
6.Before attaching the grass catcher, the mulching baffle must be removed. See Figure
a.Lift rear discharge door.
b.Remove mulching baffle.
7.Follow steps below to attach grass catcher:
a.Lift rear discharge door.
b.Place grass catcher on the pivot rod. Let go of discharge door so that it rests on the grass
catcher. See Figure
To remove grass catcher, lift rear discharge door on the mower. Lift grass catcher up and out, off of the pivot rod. Release rear discharge door to allow it to close rear opening of mower.
8.To convert to side discharge, make sure grass catcher is off of the unit, the rear mulch plug is removed, and rear discharge door is closed.
a.On the side of the mower, lift the mulching plug.
b.Slide chute hooks under hinge pin on mulching plug assembly. Lower mulching plug. See Figure
WARNING: Never operate mower unless the hooks on the grass catcher are firmly seated on the pivot rod and the rear
discharge door rests firmly against top of the grass catcher.
Adjustments
1.The cutting height adjustment lever is located above the rear left wheel. See Figure
a.Pull the lever out and away from the mower.
b.Move the lever forward or back for desired cutting height.
c.Release lever towards mower deck.
A
B
Figure
Figure
3
Setup and
Adjustment
WARNING
Never operate mower
unless the hooks on the grass catcher are firmly seated on the pivot rod and the rear discharge door rests firmly against top of the grass catcher.
B |
A |
C |
Figure | Figure |
cutting height. |
|