Controls & Features

4

 

 

 

Storage Tray

Cup Holder

Fuel Shut-Off Valve

Fuel Tank

PTO Switch

STOP

RUN

START

Hour Meter Ignition Switch

Throttle Control

SLOW

FAST

Choke Control

W A R N I N G

 

 

 

 

START

 

 

CHOKE ON

NEUTRAL

 

 

OFF

W A R N I N G

ON

 

BRAKE

 

 

 

 

Parking Brake

RH Drive

Control Lever Deck Lift

Pedal

LH Drive

Control Lever

Deck Height

Index

NOTE: References to LEFT, RIGHT, FRONT, and REAR indicate that position on the tractor when facing forward while seated in the operator’s seat.

Deck Height Index

The deck height index consists of several holes located on the front/right of the foot platform. Each hole corresponds to a 1⁄4” change in the deck height position ranging from 1” at the lowest notch to 4” at the highest notch.

Cup Holder

The cup holder is located toward the rear of the LH console to the right of the operator’s seat.

Storage Tray

The storage tray is located at the rear of the LH console.

Deck Lift Pedal

The deck lift pedal is located on the right front corner of the foot platform, and is used to raise and lower the mower deck.

To raise the mowing deck to the transport position, push the upper part of the pedal all the way forward and place the clevis pin in furthest hole from you and secure with the cotter pin. To lower the deck, remove the clevis pin and reinsert it in the desired cutting height and secure with cotter pin.

RH and LH Drive Control Levers

The RH and LH control levers are located on each side of the operator’s seat. These hinged levers pivot outward to open space to permit the operator to either sit in the tractor seat, or to dismount the tractor. The levers must be in the neutral position and locked to start the tractor engine.

Each lever controls the respective RH or LH transmission. Consequently, these levers control all of the movements of the tractor. Driving and steering utilizing these control levers is quite different from conventional tractors, and will take some practice to master. Refer to Operation for instructions on using the control levers.

12