Cub Cadet CC2025 Replacement Parts, Installing a Pre Wound Reel

Maintenance (continued)

Fig. 6-6

Loop

Fig. 6-7

Holding Slots

Fig. 6-8

Fig. 6-9

12.Insert the ends of the line into the two holding slots (Fig. 6-8).

13.Insert the ends of the line through the eyelets in the outer spool and place the inner reel with spring inside the outer spool (Fig. 6-9). Push the inner reel and outer spool together. While holding the inner reel and outer spool, grasp the ends and pull firmly to release the line from the holding slots in the reel.

NOTE: The spring must be assembled on the inner reel before reassembling the cutting attachment.

14.Hold the inner reel in place and install the bump knob by turning clockwise. Tighten securely.

Installing a Pre Wound Reel

1.Hold the outer spool with one hand and unscrew the bump knob counterclockwise (Fig. 6-1). Inspect the bolt inside the bump knob to make sure it moves freely. Replace the bump knob if damaged.

2.Remove the old inner reel from the outer spool (Fig. 6-2).

3.Remove the spring from the old inner reel (Fig. 6-2).

4.Place the spring in the new inner reel.

NOTE: The spring must be assembled on the inner reel before reassembling the cutting attachment.

5.Insert the ends of the line through the eyelets in the outer spool (Fig. 6-9).

6.Place the new inner reel inside the outer spool. Push the inner reel and outer spool together. While holding the inner reel and outer spool, grasp the ends and pull firmly to release the line from the holding slots in the reel.

7.Hold the inner reel in place and install the bump knob by turning clockwise. Tighten securely.

Replacement Parts

For replacement parts, refer to the Accessories / Replacement Parts section.

14