Cuisinart CPT-35 manual USE and Care

1

2

3

5

6

4

USE AND CARE

Unwind the power cord. Check that the crumb tray is in place and that there is nothing in the toaster slot. Plug power cord into the wall outlet.

1.Insert slice(s) of bread.

Be sure that multiple slices do not overlap and that the carriage lever is in the up position.

2.Set the browning control.

Turn dial to the desired position:

Setting	Color
1-2	light
2-4	medium
4-5	dark

Some notes on browning:

Toasting is a combination of drying and cooking of the bread. Therefore, differences in moisture level from one bread to another can result in varying toasting times.

•If bread is slightly dry, use a lower setting than you normally would.

•For very fresh bread or whole wheat bread, use a higher setting than normal.

•Breads with very uneven surfaces (such as English muffins) will require longer toasting time.

• Thickly cut pieces of bread (including bagels) will take lon-

ger to toast, sometimes significantly longer, since more moisture must evaporate from the bread before toasting can occur. Very thick (1-1/2'' or more) pieces may require two cycles.

•When toasting raisin or other fruit breads, remove any loose rai- sins, etc. from the surface of the bread before placing into the toaster. This will help prevent them from falling to the bottom or sticking to the guard wires in the slot.

Notes on specialty uses:

The following breads and pastries should be warmed by using sev- eral toasting cycles at the light setting, depending on how cold the bread is:

Toaster pastries:

Exercise caution with toaster pastries; the filling of toaster pastries can become quite hot long before the surface of the pastry becomes browned. A low setting (1-2) should be sufficient. Never leave toaster pastries unattended while toasting or warming.

Frozen waffles, pancakes, French toast:

For best results, use a few toasting cycles at a low setting (2 or 3). A longer toasting time can result in items that are toasted on the outside but cool or soggy on the inside.

Frozen bagels:

The slot of the Heat Surround™ can accommodate an unsliced frozen bagel. Depending on the size of the bagel, several toasting cycles on settings 2-4 will give best results.

3. Begin toasting.

Press the carriage lever until it locks into the down position. The heaters will position themselves based on the thickness of the bread.

4. Stop toasting.

When the toasting cycle is finished, the toast will be raised automatically. If you wish to stop the cycle before it is finished, simply:Press the ‘Cancel Button’ or lift the carriage lever slightly to release the bread carriage.

Tips:

•Never force foods into the toasting slot. Foods should fit freely between the guard wires.

•Uneven toasting is usually due to bread slices of uneven thickness.

3