Press the hour button to advance the clock to the desired time. The hour numeral moves in one hour increments. When passing 12 am, the “PM” indica- tor will illuminate in the lower left hand corner of the LCD screen.
Press the “minute” button to advance the minutes to the desired time. Minutes move in one second increments.
When complete, press the hour button again, or wait for 15 seconds and your time change will be accepted.
To Program the Brew Time
To program the brew time, press and hold the program button for two seconds. The “prog” symbol starts flashing in the lower right corner of the LCD screen.
Press the hour button to advance the clock to the desired time. The hour numeral moves in one hour increments. When passing 12 am, the “PM” indicator will illuminate in the lower left hand corner of the LCD screen.
Press the “minute” button to advance the minutes to the desired time. Minutes move in one second increments.
When complete, press the “prog” button, or wait for 15 seconds and your set time will be accepted.
To Activate the Auto Brew Cycle
To activate the auto brew mode, depress the “auto on” button. The “auto” symbol will illuminate in the upper right hand corner of the LCD screen.
The unit will now begin the brewing cycle at the programmed time. When the programmed time initiates the cycle, the red “ON” indicator light will show that the brewing cycle has started.
NOTE: The unit will continue to attempt to brew at the programmed time, each day, until the Auto On button is turned off. The red “ON” indicator light will illuminate each time the attempt to brew is made.
If there is no water in the reservoir, the unit will automatically shut off one minute later.
COFFEE PREPARATION
1.Place coffee maker on a solid flat surface. Plug into 120V outlet.
2.Open thermal carafe lid in direction of “OPEN” arrow. Fill thermal carafe with cold, fresh water. Open hinged water reservoir
cover; pour water into reservoir opening. Markings on water level indicator show amount of water needed to make desired number of cups of coffee.
TO AVOID OVERFLOW, DO NOT FILL ABOVE
Close reservoir cover.
3.Before thermal carafe is returned to platform, prewarm carafe by running warm water through carafe. If warm water is not run through carafe, when hot coffee flows into carafe during brewing cycle the glass liner may crack due to the temperature change.
Prewarming carafe will help keep coffee warmer, and also prevent glass liner from being damaged.
4.Return carafe lid to thermal carafe. To close lid, turn it in direction of “CLOSE” arrow until it fits tightly on carafe, and “POUR” arrow is aligned with spout. Return empty thermal carafe to platform. Be certain thermal carafe lid is in “CLOSED” position and is securely in place during brew cycle.
5.Open filter basket by grasping basket handle and swinging outward. Insert a filter into filter basket; make sure filter fits snugly in basket. Use a fresh filter for each carafe of coffee.
6.After placing 2 level tablespoons per cup of ground coffee into cone filter, return basket to closed position. To ensure safe operation, make sure basket is closed securely.
7.With thermal carafe and basket securely in place, press “ON” button; LED will light. CAUTION: Coffee maker becomes very hot during brew cycle; handle with extreme care as hot parts and escaping steam may cause burns.
8.The
9.An audible “beep” tone will signal when brew cycle is complete. Coffee maker will switch off automatically.
10.After coffee grounds have cooled, carefully open filter basket and discard used coffee filter
3
