Cuisinart operation manual To install the SG2-DRT-3Xin the SG2000 node

STARLINE9

To install the SG2-DRT-3X in the SG2000 node:

1If present, remove any analog transmitter that occupies the optical transmitter B or A positions as illustrated in Figure 9, and then install the double-wide SG2-DRT-3X:

Figure 9

SG2000 optical transmitter B and A locations

	Pad - optical transmitter B
	Test point - optical transmitter B
JP1	Pad - optical transmitter A
	Test point - optical transmitter A

	Optical
	transmitter B
Power	Optical
supply 2	transmitter A
	Optical
	receiver C
Power	Optical
supply 1	receiver B
	Optical
	receiver A

JP2	Pad - optical receiver C
	Test point - optical receiver C
	Pad - optical receiver B
	Test point - optical receiver B
	Pad - optical receiver A
	Test point - optical receiver A

2Verify that the XMTR B 15 dB pad has been replaced with a 5 dB pad.

3Remove all cable clamps and then remove the E-pack cover to identify the two RF ports that you want to segment.

4Remove the pad located in the ICS locations (illustrated in Figure 10) for the selected RF ports.

If there was a JXP pad in the ICS location, transfer that value to the JXP location before the ICS input.

SG2-DRT-3X Installation Sheet