INSTALLATION
&OPERATING INSTRUCTIONS
FOR
AP717
WATER FILTER
all the necessary hardware. All you need is a tube cutter, a wrench and a knife. Simply follow the easy
Ice Maker Water Filter to your refrigerator’s incoming cold water line.
You can also count on your
the problem of ice maker clogging and corrosion, and extend the life of your equipment. And each filter gives you up to six months of great tasting water. After 6 months, just replace the filter. So start enjoying tastier beverages today.
INSTALLATION INSTRUCTIONS
•Do not install on line pressure above 125psi (862kPa).
•Do not use wicking or pipe dope sealer for fitting connections into head of filter. Teflon® tape is recommended.
•Protect from freezing. Drain filter when room temperature drops below 32°F (0°C)
•Do not use with water that is microbiologically unsafe or of unknown quality without adequate disinfection before or after the system.
•Do not install in direct sunlight.
•Installation must comply with existing state or local plumbing codes.
PROCEDURE FOR INSTALLING THE FILTER
Read all instructions carefully before installing your filter.
For use on 1/4” copper or plastic tubing.
1.
2.Locate an easily accessible section of tubing.
3.Cut and remove a 6” (152.4 mm) section of tubing making sure ends are cut square.
4.Unscrew nuts from filter fittings and slip ferrules and nuts over tubing ends. If your tubing is plastic, install the supplied plastic inserts into ends of tube.