CARE AND MAINTENANCE
CARE AND MAINTENANCE
SAFEGUARD AGAINST ACCIDENTAL ERASURE
When a new recording is make, any program material previously recorded is automatically erased and only the new recording remains. To safeguard valuable recordings from being erased accidentally, the cassette and the deck are equipped with a spacial device.
On the back of the cassette there is an erase prevention tab on each side. To prevent accidental erasing, break out these tabs wish a screwdriver. If only one side of the tape is to be protected break out the tab on the left side with the side desired facing you.
Tab for side 1
Tab for side 2
Caring for Compact Discs
* Treat the disc carefully. Handle the disc only by its edges. Never allow your fingers to come in contact with the shiny, unprinted side of the disc.
*Do not attach adhesive tape, stickers, etc. To the disc label.
*Clean the disc periodically with a soft ,
*If a disc skips or gets stuck on a section of the disc, it is probably dirty or damaged(scratched).
When cleaning the disc, wipe in straight lines from the center of the center of the center of the disc to the outer edge of the disc. Never wipe in circular motions.
To record on | a tape in | which the tab has been | Tab | Break out the tab |
broken, place | a place of | adhesive tape over that |
|
|
area. |
|
|
|
|
NOTE: When a tab is broken out, the record button cannot be depressed.
Cover with tape
CASSETTE TAPE RECOMMENDATIONS
Standard tape lengths have 15
If there is any stack in the tape in the cassette, it should be removed before inserting the cassette. Place a pencil in one of the hubs and rotate toward the outside of the cassette until all stack is taken up.
* This unit is designed to play only compact discs bearing the identification logo as shown here. Other discs may not conform to the CD standard and may not play properly.
*Compact Disc should be stored in their cases after each use to avoid damage.
*Do not expose compact disc to direct sunlight, high humidity, high temperatures, or dust, etc. Prolonged exposure or extreme temperatures can warp the disc.
*Do not stick or write anything on either side of the disc. Sharp writing instruments, or the ink may damage the surface.
Cleaning the unit
*To prevent fire or shock hazard, disconnect your unit from the AC power source when cleaning.
*The finish on your unit may be cleaned with a dust cloth and cared for as other furniture. Use caution when cleaning and wiping the plastic parts.
*Mild soap and a damp cloth may be used on the front panel.
*Periodic cleaning of the tape heads, capstan and pinch roller is necessary to maintain good sound reproduction. Clean them after every 100hours of use or less if playback has deteriorated. Use a cotton swab moistened with head cleaning solution or isopropyl alcohol, then wipe dry with another swab.
| R/P | Erase |
Pinch Roller | Head | Head |
Capstan
Cotton Swab
NOTE: Never use metal objects on or near the tape heads. Do not allow and cleaning material to fall into the tape assembly.
