Connecting Power to the Speaker

PoE

Power Injector (Optional)(CyberData #010867A)

 

 

 

 

Ethernet

Ethernet

Device

Power injector

Mounting the Speaker

7

4

3

2

1

 

 

 

6 5

To mount a Wall Mount Adapter:

1.

Use the TEMPLATE on the back of this

 

document to drill four holes in the wall for the

 

anchors and screws.

2.

Place the four PLASTIC RIBBED ANCHORS in

 

the holes you prepared.

3.

Position the WALL MOUNT ADAPTER over

 

the holes.

4.

Use the four #8 SHEET METAL SCREWS to

 

secure the WALL MOUNT ADAPTER.

5.

Plug the Ethernet cable into the IP SPEAKER

 

ASSEMBLY. The yellow light verifies the

 

network connection.

 

Note: You can route the Ethernet cable through

 

the back or through the slots at the top or bottom

 

of the WALL MOUNT ADAPTER.

[254mm] 10”

Network cable routed through a wall into the rear of the Wall Mount Adapter.

6.

Position the IP SPEAKER ASSEMBLY in the

 

WALL MOUNT ADAPTER so that the IP

 

SPEAKER ASSEMBLY screw holes align with

 

the mounting holes in the WALL MOUNT

 

ADAPTER.

7.

Use three 8-32 x 1 1/4” MOUNTING SCREWS

 

to secure the IP SPEAKER ASSEMBLY to the

7” [178mm]

WALL MOUNT ADAPTER.

© 2007, CyberData Corporation, ALL RIGHTS RESERVED

930194A

Quick Reference

4 x 0.1875” [4.8mm] Hole for Mounting

Quick Reference

930194A

© 2007, CyberData Corporation, ALL RIGHTS RESERVED