Mount the Camera
Please refer to the steps below to assist you with mounting the camera. 
We suggest that you configure the camera before mounting.
1. Place the mounting bracket where you want to
position the camera and use a pencil to mark1 the holes.
2. Depending on the material of the wall or ceiling, |
|
use proper tools to drill two holes or screws | 2 |
where you marked. If the wall is made out of concrete, drill the holes first, then insert the plastic anchors to support the screws.
3. | The power and Ethernet cables can be | 3 |
| concealed behind the mounting bracket. Run | |
| the cables through the back of the mounting |
|
| bracket, securing them with the |
|
| guides. Be sure to leave enough cable length |
|
| protruding from the top to allow connection to |
|
| the camera. |
|
4. | Fasten the mounting bracket to the wall using | 4 |
| the screws provided. |
|
5. | Using the supplied thumbscrew, fasten the | 5 |
| camera to the mounting bracket. Connect the |
|
| power and Ethernet cables to the camera. |
|
6. | Adjust the angle of the arm on the mounting | 6 |
| bracket as required. Tighten the thumbscrew to |
|
lock the arm in place.
Do not overtighten the screws as this may crack the bracket.
ENGLISH
7
