D-Link DCS-5300 Using the DCS-5300 with an Internet browser

Sunday through Saturday - Select the weekdays that should perform the

following operations:

Snapshots begin at -

Snapshots stop at - Sets the time to stop the operations.

Delay second(s) before

detecting next event - Sets the time delay before restarting to check the

trigger condition when the current condition is

triggered.

Take snapshots at second(s)

after event - After a snapshot is taken because of a trigger,

another snapshot will be taken after the configured

time in seconds.

Trigger condition - There are 4 conditions related to the digital input

and three windows for motion detection. There

can be multiple selections. Select the appropriate

digital input condition according to the

characteristics of the external device. “High”, “low”

indicate external voltage input for level trigger,

while “rising”, “falling” is for edge trigger. There

are three windows shown for the name you

defined for motion detection. “Undefined” will

show instead of the window title if motion detection

is not setup yet.

Reset output - Check and save this option to reset the external

device at the digital output back to the original

state.

Using the DCS-5300 with an Internet browser

(continued)

Set the time to start operations. Setting the begin

time the same as the stop time will force the

operations to run continuously.