Dacor ACFS manual User Instructions, Decalcification Process, What to Use

User Instructions

Decalcification Process

The monthly decalcification and flushing process cleans out calcium deposits in the water and coffee delivery systems. If the calcium deposits are allowed to build up, the coffee system could malfunction.

What to Use

•Puly CAFF Detergent Tablets

•Puly Baby Cleaning (Decalcification) Powder P/N ACDC10

•Dacor JT-2 Flushing Cartridge.

•Puly Milk Liquid Detergent

caution

Decalcification powders, tablets or solutions can damage stainless steel surfaces. Immediately rinse any stainless steel surfaces that come in to contact with these cleaners with a mild solution of detergent and warm water to prevent damage. Do not pour decalcification powders, tablets or solutions down a stainless steel sink.

Instructions

The following instructions do not apply to Dacor tank equipped coffee systems (CM24T series).

4. Turn the water supply valve on the filter head to off.

Off

5.Push the HOT WATER button on the coffee system to relieve the water pressure.

6.Grasp the filter cartridge or filter bypass, depending on which one is installed. Rotate it clockwise until it stops. Pull the bypass (or filter) down and out. Some water drain off will occur.

Filter Head

The instructions below assume that the coffee system has been installed with a Dacor ACFS flushing kit as called for in the installation instructions section of this manual.

1.Remove the divider insert from the JT-2 flushing cartridge with a small screwdriver.

Flushing Divider

Cartridge Insert

2. Dissolve one packet

of Puly Baby Cleaning

(Decalcification) Powder

Bypass

7.Insert the flushing cartridge into the filter head. Push up firmly and rotate it counter- clockwise. Pull down on it to ensure that it is locked into place.

8.If other faucets or appliances other than the coffee system are connected to the filter head, disconnect and plug the water lines connected to them.

Filter

Filter Head

Flushing

Cartridge

into 12 ounces of warm

filtered water. Use a

measuring cup.

3. Fill the flushing cartridge

with the solution and top

it off with filtered water.

Reinstall the divider

insert.

9.Put a 2 quart container

or sauce pan on the drip tray under the hot water and coffee dispensers to collect the wash and rinse water. Point the hot water dispenser into the pan.

10.Turn the water supply valve on the filter head to on.

11.Push the HOT WATER button. Wait for the water to stop. Repeat this process twice to remove air.