Dacor DCT365 Installing the Burner Components, wARNING, important, CAUTION, (2 large, 2 small), (center of cooktop), Standard Burner Assembly, SimmerSear™ Burner Assembly

Installation Instructions

Installing the Burner Components

wARNING

•Never attempt to operate the cooktop with any of the burner parts removed.

•Do not attempt to adjust the burner air mixture set- tings. All adjustments are preset at the factory.

1.Remove the burner rings, burner caps and grates from their shipping packages.

2.Assemble the burners as shown. Match the burner parts to the correct size and type of burner. When installing the burner components, make sure they are centered. Twist each piece back and forth slightly until it drops completely into place. The burners will not operate properly unless all of the burner pieces are properly seated.

3.Gently set the grates on top of the spill tray. Make sure that the rubber feet are positioned in the dimples.

important

Each grate is different. Orient them as shown. Each grate has a slot on the bottom that matches up with a notch on the spill try. The slots on the grates all go toward the back of the cooktop.

Inner burner cap (bottom shown)

Outer burner cap

Burner ring

Line up

indentations on bottom of burner ring with pins on top of base.