DDW24S

Document # PG10-006

 

Revised 01/16/12 Page 2/3

 

 

Distinctive 24” Wide

PLANNING

 

 

Built-In Dishwasher

GUIDE

Location Specifications

Cutout tolerances: +1/16” (+1.6 mm), -0

 

■■ Carefully check the location where the dishwasher is to be installed. Put it in a location with convenient access, close to the kitchen sink for easy water supply and drain connection.

■■ The cabinet must enclose the dishwasher on top, back and sides.

■■ If dishwasher is installed in a corner, there must be a minimum clearance of 2” (5.1 cm) from the side wall so the door can open. See diagram.

2” (5.1 cm) min.

clearance

■■ Floor must be solid and level. All cutout surfaces must be at right angles. Surrounding cabinet must have sufficient material for attachment of the anti-tip brackets (see installation instructions).

■■ Plan the installation so that the appliance can be removed easily if service is required. The electrical outlet/junction box, water supply valve and drain connection must be installed to the right or left of the unit and accessible when dishwasher is installed. Plan the utility connections so that they can be disconnected without removing the dishwasher from the cutout.

■■ The power cable, the drain hose and water supply line must enter through one or both of the shaded locations shown above right.

■■ The access hole(s) in the cabinet for the power cord and water line shall be no bigger than 1-1/2˝ (3.8 cm) in diameter. The access hole for the drain hose shall be no bigger than 2˝ (5.0 cm) in diameter. The access holes for all three must be round and smooth. If the partition is metal, it needs to be covered with an edge protector. Call Dacor for the part number of an approved edge protector.

 

 

 

 

 

 

 

 

 

 

 

2” (5.1 cm)

 

 

 

 

 

 

 

 

34

1/2”*

 

 

 

 

 

 

 

 

 

 

(87.6 cm)

 

 

 

4” (10.2 cm)

 

 

to

 

 

 

 

36

1/2”

 

 

 

 

 

 

 

 

 

 

(92.7 cm)

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

24”

5 3/8”(61.0 cm)

(13.6 cm)

24” (61.0 cm)

Dishwasher Cutout - Front View

* If the height of the existing cutout is too low:

■■ Check to see if the cabinet face can be trimmed at the top. In many cases, when a non-standard size dishwasher has been installed previously, there is enough room inside the cabinet once the cabinet face is modified.

■■ The dishwasher can be shortened 1/4” (6.0 mm) by not installing the plastic feet provided with the unit. Extra care must be taken if the feet are not installed. Dacor is not responsible for floor damage during installation.

■■ The dishwasher can be shortened 1/4” (6.0 mm) by removing the trim pieces that surround the wash compartment opening. NOTE: Doing so will create a gap of 1/4” (6.0 mm) on the right and left side of the door.

All specifications subject to change without notice.

www.dacor.com

Phone: (800) 793-0093