Dacor ERV3015 Self-RimmingInstallation With Raised Vent (Options 2 and 3), Top View, Top View, Side View, Side View, and Cabinet Front Self-Rimmed

COMBINATION INSTALLATIONS

Document # PGCI-026		Revised 01/13/12 Page 2/2
	DR30DI Range with ERV3015	PLANNING
	Raised Vent	GUIDE

Self-Rimming Installation With Raised Vent (Options 2 and 3)

■■ Only model DR30DI may be installed with a raised vent. Use only Dacor raised vent model ERV3015.

■■ A self-rimming countertop configuration is required for raised vent installation. On installations with a raised vent, when sliding the range into position, it will stop when the rear of the control panel or side panels contact the notches toward the front of the countertop.

■■ The self-rimming installation of the DR30DI range and ERV3015 raised vent create a “built-in” look where the range trim overlaps the countertop on both sides and the raised vent overlaps the countertop in back. It is also possible, if the cabinets are deep enough, to self rim the front of the range into the cabinet face immediately behind the control panel and door trim or behind the side panels (see below). The rear range trim will partially cover the front of the raised vent chassis in back.

Model DR30DI/ERV3015 Countertop

and Cabinet Front Self-Rimmed,

3 1/4 Inch Side Panels Not Removed

Non-combustible

10” min.

3/8” min. (1.0 cm)

countertop

(25.4 cm)

rear wall recommended

overhang

both sides

2 9/16”

27 1/2” (69.9 cm)

raised vent

opening

(6.5 cm)

29 1/4” (74 3 cm)

countertop and

cabinet openin

g

Combustible side

A

wall above range

KC

Notch countertop

to

30” (76.2 cm)

Top View

Cabinet face

To countertop

below countertop

front

3/8” min. (1.0 cm)

flat countertop

Range trim resting

overhang required

behind cutout

on countertop

Cabinet face

Countertop

Back of

A

DR30DI range

side panel

rests against

cabinet face

3 1/4 inch

side panel

3/8” min. (1.0 cm) space

ERV3015 required behind ERV3015 raised vent chassis to clear stiffener

Side View

Model DR30DI
Range and ERV3015	A	B	C
Raised Vent With
Countertop and	20 5/8” *		0” (0 cm) to
Cabinet Front		NA
	(52.4 cm)		5 3/8” (13.7 cm)
Self-Rimmed,
Countertop and
Cabinet Front	23 7/8” *	NA	0” (0 cm) to
Self-Rimmed (side	(60.6 cm)		2 1/8” (5.4 cm)
panels removed)

*Cabinet face below countertop must be flush with back of notch in countertop

Countertop height for all self-rimming installations:

35 7/16” (90.0 cm) minimum, 37 7/16” (95.1 cm) maximum

Cabinet tolerances: -1/16”, (+1.6 mm) -0

Model DR30DI/ERV3015 Countertop

and Cabinet Front Self-Rimmed,

3 1/4 Inch Side Panels Removed

Non-combustible

10” min.

3/8” min. (1.0 cm)

countertop

(25.4 cm)

rear wall recommended

overhang

both sides

2 9/16”

27 1/2” (69.9 cm)

raised vent

opening

(6.5 cm)

29 1/4” (74 3 cm)

countertop and

cabinet openin

g

Combustible side

A

wall above range

CK

Notch countertop

to

30” (76.2 cm)

Top View

Cabinet face

To countertop

below countertop

front

3/8” min. (1.0 cm)

flat countertop

Range trim resting

overhang required

behind cutout

on countertop

Countertop

Cabinet face

A

DR30DI range

Back of control

panel and trim

behind door

rest against

cabinet face

3/8” min. (1.0 cm) space

required behind ERV3015

ERV3015

chassis to clear stiffener

raised vent

Range side

panel removed

Side View

All specifications subject to change without notice. www.dacor.com Phone: (800) 793-0093