Dacor PF36 Design Specifications, Installation Specifications, Product Dimensions, Tools needed

Models: PF36

1 24
Download 24 pages 19.62 Kb
Page 4
Image 4
Design Specifications

Design Specifications

Product Dimensions

The depth from the front of the door (w/o door handles) to the back of the refrigerator chassis is 26 7/8” (683 mm).

The depth of the cabinet less the door is 24 1/8” (613 mm).

The power cord is 60” (1524 mm) long.

The height from the top of the refrigerator to the floor with the leveling legs in the down position is 70 1/8” (1781 mm)

The height from the top of the refrigerator to the floor with the leveling legs in the fully extended position is 71 1/4” (1810 mm) at the front of the unit and 70 11/16” (1796 mm) at the rear of the unit.

The refrigerator width from edge to edge is 35 5/8” (905 mm).

Door Swing Dimensions

The area to the left and the right of the appliance must permit both doors to open to a minimum of 90°. Allow a minimum of

2 1/2” (64 mm) space between the side of the refrigerator doors and a corner wall.

Installation Specifications

Tools and Parts

IMPORTANT:

Installer: Leave these installation instructions with the homeowner.

Homeowner: Keep these installation instructions for future reference. Save these installation instructions for the local electrical inspector’s use.

Tools needed:

Make sure that you have the necessary tools and materials available for a proper installation.

Phillips screwdriver set

Slotted screwdriver set

Torx drive screwdriver set

Provide sufficient length 8’ (2.4 m) to allow for a minimum of a 24” (610 mm) diameter service loop of 1/4” (6 mm) copper tubing for the water line.

Copper tubing cutter

Level - 2’ (.6 m) and 4’ (1.2 m) recommended

Appliance dolly able to support 700 lbs (317 kg) and adequate manpower to handle the weight of the appliance

Various sized pliers

Allen wrench set

3/8” hex bolt nut driver or socket set

Crescent wrenches

Cordless drill and assorted drill bits

Masonite, plywood, 1/8” pressed fiberboard, cardboard or other suitable material to protect finished flooring

Appropriate materials to cover and protect the home and its furnishings during installation

Location Requirements

Your Dacor refrigerator can be recessed in an opening between cabinets or installed at the end of a cabinet run using a side panel to enclose the refrigerator.

Product Dimensions WARNING

Explosion Hazard

Keep flammable material and vapors, such as gasoline, away from the refrigerator.

Failure to do so can result in death, explosion, or fire.

IMPORTANT:

Observe all governing codes and ordinances.

To ensure proper ventilation for your refrigerator, allow for a

½” (1.25 mm) space at the top and behind the refrigerator.

Do not install the refrigerator near an oven, radiator or other heat source, nor in a location where the temperature will fall below 55°F (13°C).

Allow a minimum of 2 1/2” (64 mm) space between the side of the refrigerator and an oven or range.

The floor must be able to support the refrigerator’s weight of more than 600 lbs (272 kg), the door panels and the contents of the refrigerator.

The ceiling height must allow for side tipping radius.

The location should permit doors to open fully.

Door Swing Dimensions WARNING

Excessive Weight Hazard

Use two or more people to move and install the refrigerator. Failure to do so can result in back or other injury.

2

Page 4
Image 4
Dacor PF36 Design Specifications, Installation Specifications, Product Dimensions, Door Swing Dimensions, Tools and Parts