INLET HOSE CONNECTION
The washer should be connected to the water mains using new hose sets and old hose sets should not be reused.
In using only one water tap or in case of only one water inlet valve, connect the inlet hose to the cold water inlet valve.
Option : Be careful not to confuse hot water inlet and cold water inlet.
For Ordinary Tap
1Pull down the collar of the | 2Loosen the four screws | 3Fit the water tap adapter |
inlet hose to separate it | properly in order to fit into | into the water tap and |
from the water tap | water tap. | tighten the four screws |
adapter. |
| evenly while pushing up |
|
| the adapter so that the |
|
| rubber packing can stick |
|
| to the water tap tightly. |
|
| TAPE |
4Remove the tape, and | 5Connect the inlet hose to | 6Connect the inlet hose |
screw connector B into | the water tap adapter by | adapter of the hose to the |
connect A tightly. | pulling down the collar of | water inlet of the washer |
| the hose end. | by turning it clockwise to |
|
| be fixed tightly. |
Connector A
Connector B
• Please check the rubber packing present inside the inlet hose adapter of the hose.
For Screw-Shaped Tap
1Connect the inlet hose to the water tap by screwing the connector tightly.
Rubber
Connector
Packing
Hose Connector
2Connect the connector- inlet supplied if necessary.
Connector
inlet
Rubber
Connector
Packing
Hose Connector
3Connect the inlet hose adapter to the water inlet of a washer and turn it to be fixed.
*Check the packing in the inlet
5
