Daewoo DP-HG22

INSTALLING THE WALL FRAME SET A ON THE PLASMA DISPLAY PANEL

HOW TO INSTALL FRAME SET A ON THE UNIT

.To avoid unwanted marks on the unit, place

a protective covering over the surface you

will be working on and lay the plasma display

as shown in the picture below.

.When securing frame set A to the plasma display panel, make sure that they match the holes correctly.

.If the holes are matched incorrectly, the installation will not be successful.

.Place frame set A on the left and right

side of the unit and use the enclosed

screws (M5) to secure them tightly.

(left and right 2 each)

Note

CORRIGENDA

Replace the previous instruction (#2) with the following updated one.

Four M5 screws are not used out of total number.

Make sure the installation is secure.

Installation by professional is preffered.

Contact infomation for any question.

1-800-DAEWOO-8 #8

1-201-964-9349

Service@daewoodigital.com

MODEL: DP-HG22

Contents

Main PLASMA MONITOR (DISPLAY) WALL HANGER UNIT INSTRUCTION MANUAL DP-HG22 Page 1. PLEASE CHECK THE ITEMS SHOWN BELOW 2. IMPORTANT SAFETY INSTRUCTIONS PLEASE KEEP THESE INSTRUCTIONS FOR YOUR SAFETY AND TO PREVENT ANY DAMAGE TO THIS UNIT. PLEASE CONSULT AN AUTHORIZED SERVICE CENTER TO INST ALL THE WALL HANGER UNIT PLEASE FOLLOW THESE INSTRUCTIONS FOR YOUR SAFETY WARNING CAUTION When installing on a concrete wall When installing on a wooden wall PLEASE FOLLOW THESE SAFETY PRECAUTIONS WHEN INSTALLING OR HANDLING Paper pattern plan . 3. ASSEMBLING INSTRUCTIONS PREPARATION TO PLACE THE PROTECTIVE CAPS WHEN THE PLASMA DISPLAY IS ATTACHED TO THE STAND TO DETACH THE STAND FROM THE PLASMA DISPLAY . Page INSTALLING WALL FRAME SET B AND CONNECTING FRAME INSTALLING WALL FRAME SET B AND CONNECTING FRAME. ATTACHING PAPER PATTERN PLAN ON THE WALL . Hand drill Paper pattern plan . INSTALL THE WALL FRAME SET ON THE WALL . INSTALLING ON THE WALL HELD BY SUPPORTING WOODEN STRUCTURE . CONNECTING UPPER PART OF FRAME SET A AND FRAME SET B INSTALLING PLASMA DISPLAY ON THE WALL . set B as pictured below and push the (Z) part up gently then let go to connect. * CONNECTING LOWER PART OF FRAME SET A AND FRAME SET B . Page 4. ADJUSTING ANGLES AFTER INSTALLATION (10, 15, 20) HOW TO ADJUST VIEWING ANGLES THE FIGURES BELOW DISPLAY THE POSSIBLE PLASMA DISPLAY ANGLES. . . . . .