28
3. When there is no microwave oscillation
1) When touching START pad, oven lamp does not turn on.
Fan motor do not rotate, but cook indicator in display comes on.
* Cause : RELAY 2 does not operate. → refer to Circuit Diagram (Point 3)
- Check method
2) When touching START pad, oven lamp turns on.
Fan motor and turntable rotate and cook indicator in display comes on.
* Cause : RELAY 1 does not operate. → refer to Circuit Diagram (Point 2)
- Check method
4. When the door is opened during operation, the count down timer does not stop.
→ refer to Circuit Diagram (Point 1)
-Check method
5. When the digital clock does not operate properly.
→ refer to Circuit Diagram (Point 5)
* If clock does not keep exact time, you must check resistor R15, 16 zener diode ZD1.
STATE POINT A B
RELAY 2 ON -5VDC GND
RELAY 2 OFF GND -12VDC
STATE POINT A B
RELAY 1 ON -5VDC GND
RELAY 1 OFF GND -12VDC
STATE POINT A B
1) DOOR OPEN OPEN -5VDC
2) DOOR CLOSED CLOSE GND
CHECK NO METHOD REMEDY
1 Check the stage (ON, OFF) of the door open monitor switch by Replace door open monitor
resistance measurement. switch.
POINT WAVE FORM
A
T:16.7ms(60Hz)