NOTE : Never install the magnetron without the metallic gasket plate which is packed with each magnetron to pre- vent microwave leakage. Whenever repair work is carried out on magnetron, check the microwave leakage. It shall not exceed 4mW/cm2 for a fully assembled oven with door normally closed.
8.To remove wind guide assembly.
1)Remove a screw for earthing.
2)Remove the noise filter from the wind guide.
3)Remove a screw which secure the wind guide assembly.
4)Draw forward the wind guide assembly.
5)Pull the fan from the motor shaft.
6)Remove two screws which secure the motor shaded pole.
7)Remove the motor shaded pole.
8)Reverse the above steps for reassembly.
9. To remove H.V.transformer.
1) Remove four screws holding the H.V.transformer.
2) Remove the H.V.transformer.
3) Reverse the above steps for reassembly.
12
